Difficulty
Easy
Steps
4
Time Required
20 minutes
Sections
1
- Motherboard
- 4 steps
Flags
0
BackHover-1 Maverick
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motherboard
- Remove the twenty 15mm Phillips #1 screws from the shell of the hoverboard.
- Open the shell.
- There is one motherboard on each side of the device located near the wheels.
Remove the twenty 15mm Phillips #1 screws from the shell of the hoverboard.
Open the shell.
There is one motherboard on each side of the device located near the wheels.
1024
Step 2
- Disconnect the battery to prevent any electrical currents from coming through the wires.
Disconnect the battery to prevent any electrical currents from coming through the wires.
Step 3
- Squeeze and pull on the wires to detach them from the motherboard.
Squeeze and pull on the wires to detach them from the motherboard.
Step 4
- Remove the four 8mm Phillips #1 screws.
- Remove the motherboard from the device.
- Repeat for the other motherboard.
Remove the four 8mm Phillips #1 screws.
Remove the motherboard from the device.
Repeat for the other motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Cassandra Aarrestad
Member since: 01/23/2020
621 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team S7-G2, Paton Spring 2020
Member of Cal Poly, Team S7-G2, Paton Spring 2020
CPSU-PATON-S20S7G2
3 Members
5 Guides authored
