Hover 1 Folding E Scooter Rear Wheel Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          10 - 25 minutes            

Sections

1

• Rear Wheel
• 6 steps

Flags

0

• BackX Hover-1 Folding E-Scooter

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Rear Wheel               

• Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.
• The two screws are the same thread so find the screw that has the least torque. Only that screw will be able to removed in this step.
• Turn the hex bit 4.0 counterclockwise to reassemble the axle screws.

Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.

The two screws are the same thread so find the screw that has the least torque. Only that screw will be able to removed in this step.

Turn the hex bit 4.0 counterclockwise to reassemble the axle screws.

1024

Step 2

• Slide off the plastic side panel.

Slide off the plastic side panel.

Step 3

• Use a hex bit 4.0 to screw back in the 0.2 mm screw as tightly as possible by turning clockwise.
• You will need to hold the other screw you are not replacing with an additional hex bit 4.0, so that the screws don’t spin freely.

Use a hex bit 4.0 to screw back in the 0.2 mm screw as tightly as possible by turning clockwise.

You will need to hold the other screw you are not replacing with an additional hex bit 4.0, so that the screws don’t spin freely.

Step 4

• Flip over the scooter and use the hex bit 4.0 to remove the other 0.2 mm screw.

Flip over the scooter and use the hex bit 4.0 to remove the other 0.2 mm screw.

Step 5

• Slide off the other plastic side panel.

Slide off the other plastic side panel.

Step 6

• On the same side you removed the screw, use the bit extender to push down on the axle inside the wheel.
• The axle pops out and the wheel easily comes off.
• Two washers will pop out with the axle.

On the same side you removed the screw, use the bit extender to push down on the axle inside the wheel.

The axle pops out and the wheel easily comes off.

Two washers will pop out with the axle.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Luke Imai                     

Member since: 10/08/2018

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       Cal Poly, Team S15-G5, White Fall 2018                        

                                                  Member of Cal Poly, Team S15-G5, White Fall 2018 



                    CPSU-WHITE-F18S15G5                     


                                            4 Members                     


                                            5 Guides authored                     

jackricotta - Sep 21, 2019

Reply

Where can you get replacement rubber for the front and rear wheels?