Hover 1 Eclipse Charging Port Replacement Repair Guide

Difficulty

Moderate

Steps

4

Time Required

                          9 minutes            

Sections

1

• Charging Port
• 4 steps

Flags

0

• BackHover-1 Eclipse

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Charging Port               

• Using a Phillips #1 Screwdriver, remove the four 11mm screws that surround the edge of the left side bottom shell piece.
• Using a Phillips #1 Screwdriver, remove the four 13mm screws that surround the edge of the left side bottom shell piece.
• The order and placement of the 2 types of screws is mirrored for both sides of the bottom shell.
• Pull back and set aside the left bottom shell halve. This shell half is still wired to rest of the hoverboard.

Using a Phillips #1 Screwdriver, remove the four 11mm screws that surround the edge of the left side bottom shell piece.

Using a Phillips #1 Screwdriver, remove the four 13mm screws that surround the edge of the left side bottom shell piece.

The order and placement of the 2 types of screws is mirrored for both sides of the bottom shell.

Pull back and set aside the left bottom shell halve. This shell half is still wired to rest of the hoverboard.

1024

Step 2

• Unscrew the ring around the inside section of the charging port.

Unscrew the ring around the inside section of the charging port.

Step 3

• Follow the wire back from the charging port to where it plugs into the board.
• Unplug the wire from the board, and pull it through the ring you previously unscrewed from the charging port.

Follow the wire back from the charging port to where it plugs into the board.

Unplug the wire from the board, and pull it through the ring you previously unscrewed from the charging port.

Step 4

• Pull the charging port and wire attached to it out through the front side of the port.
• Take the plastic protector off of the charging port.

Pull the charging port and wire attached to it out through the front side of the port.

Take the plastic protector off of the charging port.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Mina Dedijer                     

Member since: 10/10/2019

545 Reputation

                                      4 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       Cal Poly, Team S12-G4, Regan Fall 2019                        

                                                  Member of Cal Poly, Team S12-G4, Regan Fall 2019 



                    CPSU-REGAN-F19S12G4                     


                                            4 Members                     


                                            5 Guides authored