Hover 1 Eclipse Bluetooth Speaker Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Bluetooth Speaker
3 steps

Flags

BackHover-1 Eclipse
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Bluetooth Speaker

Using a Phillips #1 Screwdriver, remove the four 11mm screws that surround the edge of the plug side bottom shell piece.
Using a Phillips #1 Screwdriver, remove the four 13mm screws that surround the edge of the plug side bottom shell piece.
Remove the plug side bottom shell piece

Using a Phillips #1 Screwdriver, remove the four 11mm screws that surround the edge of the plug side bottom shell piece.

Using a Phillips #1 Screwdriver, remove the four 13mm screws that surround the edge of the plug side bottom shell piece.

Remove the plug side bottom shell piece

1024

Step 2

within the plug side shell piece, there are two white and pink wires connecting the shell and the motherboard.
On the circuit board by the speaker, carefully squeeze and unplug the small white headers that connect the shell piece to the hoverboard body.
On the body of the board, follow the wires that connect the lights to the motherboard. Disconnect these wires from the motherboard by squeezing and pulling the small white headers.
Now you can fully remove the shell piece.

within the plug side shell piece, there are two white and pink wires connecting the shell and the motherboard.

On the circuit board by the speaker, carefully squeeze and unplug the small white headers that connect the shell piece to the hoverboard body.

On the body of the board, follow the wires that connect the lights to the motherboard. Disconnect these wires from the motherboard by squeezing and pulling the small white headers.

Now you can fully remove the shell piece.

Step 3

Using a Phillips #0 Screwdriver, remove the 3 screws holding the speaker to the shell.
Lift the speaker out from the casing.

Using a Phillips #0 Screwdriver, remove the 3 screws holding the speaker to the shell.

Lift the speaker out from the casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Mina Dedijer

Member since: 10/10/2019

545 Reputation

                                      4 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Cal Poly, Team S12-G4, Regan Fall 2019                        

                                                  Member of Cal Poly, Team S12-G4, Regan Fall 2019 



                    CPSU-REGAN-F19S12G4                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team