Hover 1 Coast Power Button Spring Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

Board Battery
4 steps
Power Button Spring
2 steps

Flags

BackHover-1 Coast
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

This will be a moderately difficult task to complete as you will use tools that not everyone probably has but are common for most electronics repairs.

Provided to you, is a list of detailed instructions on how to properly, and safely replace the spring. For parts please go ++here++ to look at how to purchase new parts. For any inquiries, please take a look at the operator’s manual link ++here++.

What you need

Step 1

              Board Battery

To remove the battery on the Hover-1 Coast, you must uncover the screws on the top of the board.
Using a pick tool, puncture the grip tape and expose the screws.
Loosen all four 1" screws using a Phillips #1 screwdriver.

To remove the battery on the Hover-1 Coast, you must uncover the screws on the top of the board.

Using a pick tool, puncture the grip tape and expose the screws.

Loosen all four 1" screws using a Phillips #1 screwdriver.

1024

Step 2

Now pull the black protective cover off the board.
Locate the battery.

Now pull the black protective cover off the board.

Locate the battery.

Step 3

The battery is connected by these two sets of wires.
Remove the yellow wire first by pulling the two wires gently in opposite directions.
Now pull apart the black wire by gently pulling the two wires in opposite directions.

The battery is connected by these two sets of wires.

Remove the yellow wire first by pulling the two wires gently in opposite directions.

Now pull apart the black wire by gently pulling the two wires in opposite directions.

Step 4

Once the battery has been disconnected, gently pry the battery upward.
It is important to use a plastic opening tool to avoid puncturing the battery.
Once the battery is freed, remove it with your hands.
The battery is glued to the case and will require some effort to remove.

Once the battery has been disconnected, gently pry the battery upward.

It is important to use a plastic opening tool to avoid puncturing the battery.

Once the battery is freed, remove it with your hands.

The battery is glued to the case and will require some effort to remove.

Step 5

              Power Button Spring

Using the Phillips #1 screwdriver, loosen the two screws and place the power button somewhere safe.

Using the Phillips #1 screwdriver, loosen the two screws and place the power button somewhere safe.

Step 6

Remove the unwanted spring and place your new spring back into the hole.

Remove the unwanted spring and place your new spring back into the hole.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Jace Oppenlander

Member since: 10/04/2018

545 Reputation

                                      4 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Linn Benton Community College, Team S2-G2, Karnes Fall 2018                        

                                                  Member of Linn Benton Community College, Team S2-G2, Karnes Fall 2018 



                    LBCC-KARNES-F18S2G2                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team