Difficulty

Easy

Steps

6

Time Required

                          15 - 20 minutes

Sections

2

  • Hover-1 Chrome Disassembly
  • 3 steps
  • LED Headlights
  • 3 steps

Flags

0

  • BackHover-1 Chrome

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Hover-1 Chrome Disassembly
  • Flip the Hover-1 Chrome upside down.
  • Use a Phillips #2 screwdriver to remove the fourteen 14 mm screws from the bottom of the Hover-1.
  • Break the two black tape circles, and remove the two 15 mm Phillips screws underneath.

Flip the Hover-1 Chrome upside down.

Use a Phillips #2 screwdriver to remove the fourteen 14 mm screws from the bottom of the Hover-1.

Break the two black tape circles, and remove the two 15 mm Phillips screws underneath.

1024

Step 2

  • Lift the shell without the speaker grille and unplug the battery.

Lift the shell without the speaker grille and unplug the battery.

Step 3

  • Lift the shell with the speaker grille.
  • Unplug the speaker.
  • Unplug the LEDs.
  • Unplug the power button
  • Unplug the charging port.

Lift the shell with the speaker grille.

Unplug the speaker.

Unplug the LEDs.

Unplug the power button

Unplug the charging port.

Step 4

              LED Headlights
  • Use a Phillips #2 screwdriver to remove the two 2 mm screws on either side of the LEDs.
  • Remove the LED board.
  • The LEDs are not symmetrical. This step is for the right side of the board, next to the power button. The left side is covered next.

Use a Phillips #2 screwdriver to remove the two 2 mm screws on either side of the LEDs.

Remove the LED board.

The LEDs are not symmetrical. This step is for the right side of the board, next to the power button. The left side is covered next.

Step 5

  • Locate the LED headlights on the left side of the board.
  • Pull the red wire attached to the LEDs perpendicular to the other wires to disconnect it.

Locate the LED headlights on the left side of the board.

Pull the red wire attached to the LEDs perpendicular to the other wires to disconnect it.

Step 6

  • Use a Phillips #2 screwdriver to remove the two 2 mm screws on either side of the LEDs.
  • Remove the LED board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Nick McGuire

Member since: 10/08/2018

551 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team S4-G1, White Fall 2018                        

                                                  Member of Cal Poly, Team S4-G1, White Fall 2018 



                    CPSU-WHITE-F18S4G1                     


                                            4 Members                     


                                            6 Guides authored