Difficulty

Easy

Steps

8

Time Required

                          10 - 15 minutes

Sections

2

  • Unplugging the Battery
  • 5 steps
  • LED Headlight
  • 3 steps

Flags

0

  • BackHover-1 Charger

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Make sure to wear an anti-static wrist strap to protect the electronics against buildup of static electricity. Some screw housings are fragile; they may fall apart when the screw is removed.

What you need

Step 1

              Unplugging the Battery
  • Flip the hoverboard over so that the warning label is facing up.
  • Remove the twelve 12 mm screws with a Phillips #2 screwdriver.
  • Remove the four 10 mm screws with a Phillips #2 screwdriver.
  • The screws nearest to the wheels may be hard to access. Be sure to use a long, thin screwdriver.

Flip the hoverboard over so that the warning label is facing up.

Remove the twelve 12 mm screws with a Phillips #2 screwdriver.

Remove the four 10 mm screws with a Phillips #2 screwdriver.

The screws nearest to the wheels may be hard to access. Be sure to use a long, thin screwdriver.

1024

Step 2

  • Pull the right cover away from the hoverboard to expose the battery.

Pull the right cover away from the hoverboard to expose the battery.

Step 3

  • Disconnect the two pronged black and yellow cable.

Disconnect the two pronged black and yellow cable.

Step 4

  • Pull the left cover away from the hoverboard.

Pull the left cover away from the hoverboard.

Step 5

  • Disconnect the two pronged black and yellow cable. The battery is now fully disconnected.

Disconnect the two pronged black and yellow cable. The battery is now fully disconnected.

Step 6

              LED Headlight
  • Remove the black and red two pin connector from the circuitboard.

Remove the black and red two pin connector from the circuitboard.

Step 7

  • Remove the two 12mm screws holding the LED to the front cover with a Phillips #2 screwdriver.
  • Our Hoverboard was missing a screw in the LED housing. Yours may or may not be missing screws as well.

Remove the two 12mm screws holding the LED to the front cover with a Phillips #2 screwdriver.

Our Hoverboard was missing a screw in the LED housing. Yours may or may not be missing screws as well.

Step 8

  • With the wire unplugged and screws removed, you can now safely seperate the LED from the Hoverboard.

With the wire unplugged and screws removed, you can now safely seperate the LED from the Hoverboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Benji Forest

Member since: 10/10/2019

263 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Cal Poly, Team S12-G1, Regan Fall 2019                        

                                                  Member of Cal Poly, Team S12-G1, Regan Fall 2019 



                    CPSU-REGAN-F19S12G1                     


                                            4 Members                     


                                            6 Guides authored