Difficulty

Moderate

Steps

6

Time Required

                          15 minutes

Sections

1

  • Rotating Brush Roll
  • 6 steps

Flags

0

  • BackHoover Presto 2-in-1 Cordless Stick

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rotating Brush Roll
  • Press grey release button on stick vacuum to release vacuum head.

Press grey release button on stick vacuum to release vacuum head.

1024

Step 2

  • Locate the circular black turn switch, which is in the upper right corner of the backside of the vacuum head
  • Using a metal spudger, place the tool in the indent of the circular turn switch and turn it from the left to the right or from the “locked” symbol to the “unlocked” symbol

Locate the circular black turn switch, which is in the upper right corner of the backside of the vacuum head

Using a metal spudger, place the tool in the indent of the circular turn switch and turn it from the left to the right or from the “locked” symbol to the “unlocked” symbol

Step 3

  • Flip the vacuum head over so that the wheels and screws are facing you.
  • Using a PH #1 screw driver, remove the four 15mm screws from each corner of the backside of the vacuum head.

Flip the vacuum head over so that the wheels and screws are facing you.

Using a PH #1 screw driver, remove the four 15mm screws from each corner of the backside of the vacuum head.

Step 4

  • Locate the two wheels in the upper half of the vacuum head and remove them by sticking the metal spudger tool underneath the wheel and pushing it towards you until it pops out.
  • Remove the two 15mm screws located under the wheels with a PH #1 screw driver.

Locate the two wheels in the upper half of the vacuum head and remove them by sticking the metal spudger tool underneath the wheel and pushing it towards you until it pops out.

Remove the two 15mm screws located under the wheels with a PH #1 screw driver.

Step 5

  • Using a firm grip, pull the two halves of the vacuum head away from each other until they are completely separated

Using a firm grip, pull the two halves of the vacuum head away from each other until they are completely separated

Step 6

  • Remove brush from inside the vacuum head.

Remove brush from inside the vacuum head.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    katia zubieta

Member since: 09/11/2017

422 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       CSU Fullerton, Team S2-G6, Bruce Fall 2017                        

                                                  Member of CSU Fullerton, Team S2-G6, Bruce Fall 2017 



                    CSUF-BRUCE-F17S2G6                     


                                            3 Members                     


                                            8 Guides authored