Hoover Power Path Pro Advanced Power Switch Replacement Repair Guide

Difficulty

Difficult

Steps

8

Time Required

                          20 minutes            

Sections

1

• Power Switch
• 8 steps

Flags

0

• BackHoover Power Path Pro Advanced

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Power Switch               

• Remove the lower brushroll from the bottom of the cleaner.

Remove the lower brushroll from the bottom of the cleaner.

1024

Step 2

• Use a long #2 Philips head to remove the 8 numbered screws on the bottom of the cleaner (They will also be indicated on the bottom of the vacuum).

Use a long #2 Philips head to remove the 8 numbered screws on the bottom of the cleaner (They will also be indicated on the bottom of the vacuum).

Step 3

• Pull the red handle to remove the front suction unit from the cleaner.

Pull the red handle to remove the front suction unit from the cleaner.

Step 4

• Unscrew the hose by using a Phillips #2 to detach it from the top cover of the cleaner.

Unscrew the hose by using a Phillips #2 to detach it from the top cover of the cleaner.

Step 5

• Push down on the handle release button. Lift the edge of top cover connected to this button.
• Repeat the above step for the “On/Off” button.
• Pull entire top cover off.
• Caution: when pulling the handle release button, make sure the top of the cleaner does not fall.

Push down on the handle release button. Lift the edge of top cover connected to this button.

Repeat the above step for the “On/Off” button.

Pull entire top cover off.

Caution: when pulling the handle release button, make sure the top of the cleaner does not fall.

Step 6

• Remove the “On/Off” cap by pulling it upwards with caution.

Remove the “On/Off” cap by pulling it upwards with caution.

Step 7

• Use a long #2 Philips head to remove the two screws from the arched grey piece.

Use a long #2 Philips head to remove the two screws from the arched grey piece.

Step 8

• Pull out the red power the red power switch.

Pull out the red power the red power switch.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.                                             

Author

                                      with 3 other contributors 

                    Jose Andres Gonzalez Valdes                     

Member since: 01/22/2018

682 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team S16-G5, Banghart Winter 2018                        

                                                  Member of Cal Poly, Team S16-G5, Banghart Winter 2018 



                    CPSU-BANGHART-W18S16G5                     


                                            5 Members                     


                                            15 Guides authored                     

martahayner - May 14, 2019

Reply

What is the part number?

debmccrimm - Sep 8, 2019

Reply

Thanks so much!!

frank - Aug 10, 2020

Reply

you have to test the switch, mine tested ok which led me to the fuse between the motor and switch. It was bad, parts warehouse part # 440004065 does the trick.