Difficulty

Difficult

Steps

7

Time Required

                          15 - 20 minutes

Sections

3

  • Case
  • 2 steps
  • Control Panel
  • 2 steps
  • Rotation Button
  • 3 steps

Flags

0

  • BackHoneywell HY-204

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Case
  • Before you begin, be sure to unplug the fan.
  • Remove the four 14 mm screws from the back of the device using the Phillips #0 Screwdriver.

Before you begin, be sure to unplug the fan.

Remove the four 14 mm screws from the back of the device using the Phillips #0 Screwdriver.

1024

Step 2

  • Pull the front and back parts of the case away from each other until the back is free from the front. This may require a large amount of force.

Pull the front and back parts of the case away from each other until the back is free from the front. This may require a large amount of force.

Step 3

              Control Panel
  • Remove the two 3mm screws found just below the top of the device using the Phillips #0 Screwdriver.

Remove the two 3mm screws found just below the top of the device using the Phillips #0 Screwdriver.

Step 4

  • Pry off the control panel by forcefully lifting the tab located inside the front of the fan with the plastic opening tool.

Pry off the control panel by forcefully lifting the tab located inside the front of the fan with the plastic opening tool.

Step 5

              Rotation Button
  • Remove the two 10mm Phillips #0 screws that are located next to the rotation button.

Remove the two 10mm Phillips #0 screws that are located next to the rotation button.

Step 6

  • Peel back the heat shrink tubing on both wires connecting to the button.

Peel back the heat shrink tubing on both wires connecting to the button.

Step 7

  • Caution The soldering iron is very hot, be careful to avoid burns.
  • Desolder the two wires connected to the button and remove the button.

Caution The soldering iron is very hot, be careful to avoid burns.

Desolder the two wires connected to the button and remove the button.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Nolan Ernotte

Member since: 10/14/2014

366 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 10-40, Amido Fall 2014                        

                                                  Member of Cal Poly, Team 10-40, Amido Fall 2014 



                    CPSU-AMIDO-F14S10G40                     


                                            3 Members                     


                                            7 Guides authored