Honeywell Hy 204 Febreze Dial Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          15 - 20 minutes            

Sections

3

• Case
• 2 steps
• Control Panel
• 2 steps
• Febreze Dial
• 2 steps

Flags

0

• BackHoneywell HY-204

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Case               

• Before you begin, be sure to unplug the fan.
• Remove the four 14 mm screws from the back of the device using the Phillips #0 Screwdriver.

Before you begin, be sure to unplug the fan.

Remove the four 14 mm screws from the back of the device using the Phillips #0 Screwdriver.

1024

Step 2

• Pull the front and back parts of the case away from each other until the back is free from the front. This may require a large amount of force.

Pull the front and back parts of the case away from each other until the back is free from the front. This may require a large amount of force.

Step 3

              Control Panel               

• Remove the two 3mm screws found just below the top of the device using the Phillips #0 Screwdriver.

Remove the two 3mm screws found just below the top of the device using the Phillips #0 Screwdriver.

Step 4

• Pry off the control panel by forcefully lifting the tab located inside the front of the fan with the plastic opening tool.

Pry off the control panel by forcefully lifting the tab located inside the front of the fan with the plastic opening tool.

Step 5

              Febreze Dial               

• Remove the two 3mm Phillips #0 screws from the back of the black dial box.

Remove the two 3mm Phillips #0 screws from the back of the black dial box.

Step 6

• Be careful not to separate the wires from the black dial box during separation, or you will have to re-solder them.
• Pull the dial carefully, but forcefully, straight away from the black dial box. Do not twist the dial button while removing it.
• When reassembling, screw the black box on first, line up the hole on the dial with the shaft on the black box, and push the dial into place.

Be careful not to separate the wires from the black dial box during separation, or you will have to re-solder them.

Pull the dial carefully, but forcefully, straight away from the black dial box. Do not twist the dial button while removing it.

When reassembling, screw the black box on first, line up the hole on the dial with the shaft on the black box, and push the dial into place.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Armando Jacob Espinoza                     

Member since: 10/14/2014

500 Reputation

                                      3 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       Cal Poly, Team 10-40, Amido Fall 2014                        

                                                  Member of Cal Poly, Team 10-40, Amido Fall 2014 



                    CPSU-AMIDO-F14S10G40                     


                                            3 Members                     


                                            7 Guides authored