Difficulty
Moderate
Steps
4
Time Required
10 - 15 minutes
Sections
2
- Case
- 2 steps
- Control Panel
- 2 steps
Flags
0
BackHoneywell HY-204
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Case
- Before you begin, be sure to unplug the fan.
- Remove the four 14 mm screws from the back of the device using the Phillips #0 Screwdriver.
Before you begin, be sure to unplug the fan.
Remove the four 14 mm screws from the back of the device using the Phillips #0 Screwdriver.
1024
Step 2
- Pull the front and back parts of the case away from each other until the back is free from the front. This may require a large amount of force.
Pull the front and back parts of the case away from each other until the back is free from the front. This may require a large amount of force.
Step 3
Control Panel
- Remove the two 3mm screws found just below the top of the device using the Phillips #0 Screwdriver.
Remove the two 3mm screws found just below the top of the device using the Phillips #0 Screwdriver.
Step 4
- Pry off the control panel by forcefully lifting the tab located inside the front of the fan with the plastic opening tool.
Pry off the control panel by forcefully lifting the tab located inside the front of the fan with the plastic opening tool.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Nolan Ernotte
Member since: 10/14/2014
366 Reputation
3 Guides authored
Badges:
11
+8 more badges
Team
Cal Poly, Team 10-40, Amido Fall 2014
Member of Cal Poly, Team 10-40, Amido Fall 2014
CPSU-AMIDO-F14S10G40
3 Members
7 Guides authored
