Difficulty

Easy

Steps

10

Time Required

                          3 minutes

Sections

4

  • Housing
  • 3 steps
  • Circuit Board Removal
  • 1 step
  • Fan
  • 3 steps
  • Thermostat
  • 3 steps

Flags

1

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackHolmes HEH8031 Space Heater

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Housing
  • Ensure the device is unplugged from the wall outlet.

Ensure the device is unplugged from the wall outlet.

1024

Step 2

  • Remove eight 12-mm Phillips #2 screws from the back cover.

Remove eight 12-mm Phillips #2 screws from the back cover.

Step 3

  • Turn heater over so the controls are facing up.
  • Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.
  • Internal wires are connected to both halves of the housing. Be careful when separating the housing.

Turn heater over so the controls are facing up.

Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.

Internal wires are connected to both halves of the housing. Be careful when separating the housing.

Step 4

              Circuit Board Removal
  • Remove four 12mm Phillips #2 screws from the circuit board.

Remove four 12mm Phillips #2 screws from the circuit board.

Step 5

              Fan
  • Remove two Phillips #2 12mm screws from housing

Remove two Phillips #2 12mm screws from housing

Step 6

  • Remove zip tie from wire with pliers

Remove zip tie from wire with pliers

Step 7

  • Separate fan assembly from heating coil

Separate fan assembly from heating coil

Step 8

              Thermostat
  • Remove 1 Phillips #2 screw

Remove 1 Phillips #2 screw

Step 9

  • Remove thermostat from rear housing

Remove thermostat from rear housing

Step 10

  • remove solder from thermostat wire on circuit board
  • Soldering iron will be hot

remove solder from thermostat wire on circuit board

Soldering iron will be hot

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Richard S Woodruff

Member since: 10/12/2016

142 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       IUPUI, Team 2-1, Baechle Fall 2016                        

                                                  Member of IUPUI, Team 2-1, Baechle Fall 2016 



                    IUPUI-BAECHLE-F16S2G1                     


                                            4 Members                     


                                            8 Guides authored