Holmes Heh8031 Power Cord Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          10 minutes            

Sections

2

• Housing
• 3 steps
• Power Cord
• 3 steps

Flags

0

• BackHolmes HEH8031 Space Heater

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Housing               

• Ensure the device is unplugged from the wall outlet.

Ensure the device is unplugged from the wall outlet.

1024

Step 2

• Remove eight 12-mm Phillips #2 screws from the back cover.

Remove eight 12-mm Phillips #2 screws from the back cover.

Step 3

• Turn heater over so the controls are facing up.
• Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.
• Internal wires are connected to both halves of the housing. Be careful when separating the housing.

Turn heater over so the controls are facing up.

Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.

Internal wires are connected to both halves of the housing. Be careful when separating the housing.

Step 4

              Power Cord               

• Decrimp the wire nuts from both wire connections.
• Remove wire nuts to expose wire strands.
• Separate all connected wires.

Decrimp the wire nuts from both wire connections.

Remove wire nuts to expose wire strands.

Separate all connected wires.

Step 5

• Pull on the cord from the outside of the heater with great finesse. At the same time, push the cord clamp out of the housing from the inside.
• Separate the two halves of the cord clamp and remove from cord.

Pull on the cord from the outside of the heater with great finesse. At the same time, push the cord clamp out of the housing from the inside.

Separate the two halves of the cord clamp and remove from cord.

Step 6

• Prepare the replacement cord by cutting the negative branch (black) at least 8 inches shorter than the positive branch (white).
• Strip at least 3/4 inch of insulation from the cord to expose bare wire.
• Twist wire ends to form a tight braid.

Prepare the replacement cord by cutting the negative branch (black) at least 8 inches shorter than the positive branch (white).

Strip at least 3/4 inch of insulation from the cord to expose bare wire.

Twist wire ends to form a tight braid.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 1 other contributor 

                    Deanna Jack                     

Member since: 10/12/2016

333 Reputation

                                      4 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       IUPUI, Team 2-1, Baechle Fall 2016                        

                                                  Member of IUPUI, Team 2-1, Baechle Fall 2016 



                    IUPUI-BAECHLE-F16S2G1                     


                                            4 Members                     


                                            8 Guides authored                     

Terri Allen - Jan 3, 2022

Reply

Are there substitute power cord for Holmes HEH8031 power cord replacement?