Hkc P774A Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Digitizer
3 steps
Camera
2 steps

Flags

BackHKC P774A
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Digitizer

Insert the flat end of the spudger into the side of the device
This will create a gap between the device and screen housing.
Insert the plastic opening tool into this gap and move it along this gap.
Make sure not to bent the digitizer during this step.
The screen housing and device will now be separated.

Insert the flat end of the spudger into the side of the device

This will create a gap between the device and screen housing.

Insert the plastic opening tool into this gap and move it along this gap.

Make sure not to bent the digitizer during this step.

The screen housing and device will now be separated.

1024

Step 2

Once the digitizer has been been removed from the body, disconnect the digitizer band from the motherboard.
Two small black pins (circled in red) will need to be unlocked.
Unlock the pins by pulling them outward with the tweezers.
Make sure the pins are released entirely before attempting to remove the band.
Remove the band using the tweezers.

Once the digitizer has been been removed from the body, disconnect the digitizer band from the motherboard.

Two small black pins (circled in red) will need to be unlocked.

Unlock the pins by pulling them outward with the tweezers.

Make sure the pins are released entirely before attempting to remove the band.

Remove the band using the tweezers.

Step 3

Once the digitizer has been disconnected from the motherboard, the LCD screen must be removed from the digitizer.
Push open the tabs (circled in red) using the flat end of the plastic spudger.
Be sure not to bend the digitizer while prying.
Continue to release all tabs while continuing to pry the LCD away from the digitizer.

Once the digitizer has been disconnected from the motherboard, the LCD screen must be removed from the digitizer.

Push open the tabs (circled in red) using the flat end of the plastic spudger.

Be sure not to bend the digitizer while prying.

Continue to release all tabs while continuing to pry the LCD away from the digitizer.

Step 4

              Camera

Use the tweezers to pull out the black pins (circled in red).
Use the tweezers to remove the camera band from the motherboard.
Handle the band with care.

Use the tweezers to pull out the black pins (circled in red).

Use the tweezers to remove the camera band from the motherboard.

Handle the band with care.

Step 5

Use the flat end of the plastic spudger to pry the camera lens from the case.
Use the tweezers to remove the camera and band.

Use the flat end of the plastic spudger to pry the camera lens from the case.

Use the tweezers to remove the camera and band.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Sean McCauley

Member since: 10/26/2015

512 Reputation

                                      4 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Montana Tech, Team 10-1, Shirk Fall 2015                        

                                                  Member of Montana Tech, Team 10-1, Shirk Fall 2015 



                    MTUM-SHIRK-F15S10G1                     


                                            4 Members                     


                                            8 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team