Hipstreet Titan 2 Hd Rear Case Replacement Repair Guide

Difficulty

Easy

Steps

6

Time Required

                          5 - 10 minutes            

Sections

1

• Rear Case
• 6 steps

Flags

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

• BackHipstreet Titan 2 HD

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Rear Case               

• Using the PH#00 screwdriver, remove the two 0.145 inch Phillips head screws.
• The screws are located on the bottom face of the device, near the power and volume controls.

Using the PH#00 screwdriver, remove the two 0.145 inch Phillips head screws.

The screws are located on the bottom face of the device, near the power and volume controls.

1024

Step 2

• Place the small suction cup on your screen.
• Moisturize the bottom of the suction cup to ensure a proper seal.
• If the screen is cracked, the suction cup may not seal correctly; too much pressure may crack or damage the screen.

Place the small suction cup on your screen.

Moisturize the bottom of the suction cup to ensure a proper seal.

If the screen is cracked, the suction cup may not seal correctly; too much pressure may crack or damage the screen.

Step 3

• Insert the plastic opening tool between the screen cover and rear cover of the tablet.
• Grasp the small suction cup.

Insert the plastic opening tool between the screen cover and rear cover of the tablet.

Grasp the small suction cup.

Step 4

• Slide the plastic opening tool along device edge to separate the screen cover from the rear cover.
• Pull upward on the small suction cup handle while sliding the opening tool.
• When sliding the plastic opening tool, avoid sliding the tool too far into the cover. This could damage the speaker connector on the back cover.

Slide the plastic opening tool along device edge to separate the screen cover from the rear cover.

Pull upward on the small suction cup handle while sliding the opening tool.

When sliding the plastic opening tool, avoid sliding the tool too far into the cover. This could damage the speaker connector on the back cover.

Step 5

• Use the plastic opening tool to remove the speaker from the rear cover.
• The speaker is held in place with adhesive and is easily removed.
• Do not pull on the speaker wires. This could damage the soldering connections.

Use the plastic opening tool to remove the speaker from the rear cover.

The speaker is held in place with adhesive and is easily removed.

Do not pull on the speaker wires. This could damage the soldering connections.

Step 6

• Once the speaker is disconnected, the cover removal is complete.

Once the speaker is disconnected, the cover removal is complete.

Congratulations your tear down is complete. To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 9 other contributors 

                    Jeffrey                     

Member since: 03/11/2015

766 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       Colorado Springs, Team 5-6, Panko Spring 2015                        

                                                  Member of Colorado Springs, Team 5-6, Panko Spring 2015 



                    UCCS-PANKO-S15S5G6                     


                                            3 Members                     


                                            10 Guides authored