Difficulty

Moderate

Steps

3

Time Required

                          30 minutes - 1 hour

Sections

1

  • Thermostat cut off
  • 3 steps

Flags

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackFast Fix

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Step 1

              Thermostat cut off
  • First of all we need to make room behind the dryer. To do this a dolly is recommended since its about 250lbs and can definitely scratch the floor if drug. Pull the machine out slowly until there is room to fit behind and still have arm space.
  • The dryer vent, hot/cold water and drainage pipes can remain attached. But for safety unplugging the machine is mandatory. The plug is big and may require a little extra force to remove.

First of all we need to make room behind the dryer. To do this a dolly is recommended since its about 250lbs and can definitely scratch the floor if drug. Pull the machine out slowly until there is room to fit behind and still have arm space.

The dryer vent, hot/cold water and drainage pipes can remain attached. But for safety unplugging the machine is mandatory. The plug is big and may require a little extra force to remove.

1024

Step 2

  • Now that we have safe access to the rear panel we must first remove the small plate on the back of the dryer. To do this simply unscrew the single screw at the top of the small plate and lift the plate out.

Now that we have safe access to the rear panel we must first remove the small plate on the back of the dryer. To do this simply unscrew the single screw at the top of the small plate and lift the plate out.

Step 3

  • After setting aside the small panel we can proceed with the large panel.
  • There is no special method or order to removing the screws. But on the last screw be aware the panel will fall so holding the panel is strongly suggested when removing the last screw.

After setting aside the small panel we can proceed with the large panel.

There is no special method or order to removing the screws. But on the last screw be aware the panel will fall so holding the panel is strongly suggested when removing the last screw.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Nicholas Steele

Member since: 02/10/2019

97 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       Eastern Washington University, Team S27-G20, Munoz Winter 2019                        

                                                  Member of Eastern Washington University, Team S27-G20, Munoz Winter 2019 



                    EWU-MUNOZ-W19S27G20                     


                                            1 Member                     


                                            1 Guide authored