Difficulty
Difficult
Steps
8
Time Required
30 minutes
Sections
3
- Bowl and Lid
- 1 step
- Gears
- 3 steps
- Motor
- 4 steps
Flags
0
BackHamilton Beach 70740
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Bowl and Lid
- Turn the bowl counterclockwise and lift.
Turn the bowl counterclockwise and lift.
1024
Step 2
Gears
- Use the nylon spudger to remove the plastic screw covers.
Use the nylon spudger to remove the plastic screw covers.
Step 3
- Using a #2 Phillips head screwdriver, remove the four 10 mm screws and pull the shaft straight upwards to uncover gears.
Using a #2 Phillips head screwdriver, remove the four 10 mm screws and pull the shaft straight upwards to uncover gears.
Step 4
- Firmly grasp center piece of gear mechanism and pull straight upward.
Firmly grasp center piece of gear mechanism and pull straight upward.
Step 5
Motor
- Using a #2 Phillips head screwdriver, remove the two 11 mm screws and pull the rubber suction cups straight up.
Using a #2 Phillips head screwdriver, remove the two 11 mm screws and pull the rubber suction cups straight up.
Step 6
- Using the heavy duty plastic spudger remove the four rubber caps.
- Using a #2 Phillips head screwdriver, remove the four 11 mm screws inside each of the bases legs.
- Pull the base straight up to remove it from the processor.
Using the heavy duty plastic spudger remove the four rubber caps.
Using a #2 Phillips head screwdriver, remove the four 11 mm screws inside each of the bases legs.
Pull the base straight up to remove it from the processor.
Step 7
- Using a #2 Phillips head screwdriver, remove the four 9 mm screws.
- From the open base pull the motor straight out.
Using a #2 Phillips head screwdriver, remove the four 9 mm screws.
From the open base pull the motor straight out.
Step 8
- Using the wire stripper crimping tool cut the black wire connection from the power cord to the motor.
- Using the wire stripper crimping tool strip the ends of each of the black cords and insert them into the opposite ends of a parallel connector, then crimp firmly.
- Using the wire stripper crimping tool cut the four red wire connections from the switch to the motor and then rewire the four red wires together in a wiring connector cap.
- Using the wire stripper crimping tool strip the ends of each red wire and insert them into a new wiring connector cap, then crimp firmly.
Using the wire stripper crimping tool cut the black wire connection from the power cord to the motor.
Using the wire stripper crimping tool strip the ends of each of the black cords and insert them into the opposite ends of a parallel connector, then crimp firmly.
Using the wire stripper crimping tool cut the four red wire connections from the switch to the motor and then rewire the four red wires together in a wiring connector cap.
Using the wire stripper crimping tool strip the ends of each red wire and insert them into a new wiring connector cap, then crimp firmly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Travis Williams
Member since: 02/02/2017
552 Reputation
5 Guides authored
Badges:
6
+3 more badges
Team
USF Tampa, Team 17-4, Blackwell Spring 2017
Member of USF Tampa, Team 17-4, Blackwell Spring 2017
USFT-BLACKWELL-S17S17G4
3 Members
7 Guides authored
