Hamilton Beach 51101Ba Power Button Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 minutes

Sections

Power Button
6 steps

Flags

BackHamilton Beach 51101BA
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Power Button

Remove the container from the base.
Hold the blender and the container, then twist the container in a clockwise motion.
Make sure to follow the lock and unlock markings on the container.

Remove the container from the base.

Hold the blender and the container, then twist the container in a clockwise motion.

Make sure to follow the lock and unlock markings on the container.

1024

Step 2

Turn the blender so the bottom is facing you.
Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the base.

Turn the blender so the bottom is facing you.

Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the base.

Step 3

Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the motor platform.

Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the motor platform.

Step 4

Unhinge the motor platform from the blender.
You may need a plastic spudger to unhinge the plastic bottom piece from the base of the blender.
You do not need to completely remove this piece from the base.

Unhinge the motor platform from the blender.

You may need a plastic spudger to unhinge the plastic bottom piece from the base of the blender.

You do not need to completely remove this piece from the base.

Step 5

Pull out the rectangular green piece.
This is the actual power button.

Pull out the rectangular green piece.

This is the actual power button.

Step 6

Some experience in soldering is required!
On the back of the power button, desolder the red and grey wires that are connected to the piece.

Some experience in soldering is required!

On the back of the power button, desolder the red and grey wires that are connected to the piece.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors

                    Brandon Nunez

Member since: 08/28/2015

277 Reputation

                                      2 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 2-5, Sullivan Fall 2015                        

                                                  Member of USF Tampa, Team 2-5, Sullivan Fall 2015 



                    USFT-SULLIVAN-F15S2G5                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team