Hamilton Beach 51101Ba Motor Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          10 minutes

Sections

Rotor
6 steps
Motor
3 steps

Flags

BackHamilton Beach 51101BA
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Rotor

Remove the container from the blender.
Hold the blender and the container, then twist the container in a clockwise motion.
Make sure to follow the lock and unlock markings on the container.

Remove the container from the blender.

Hold the blender and the container, then twist the container in a clockwise motion.

Make sure to follow the lock and unlock markings on the container.

1024

Step 2

Turn the blender so the bottom is facing you.
Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the base.

Turn the blender so the bottom is facing you.

Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the base.

Step 3

Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the motor platform.

Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the motor platform.

Step 4

Unhinge the plastic motor platform from the blender.
You may need a plastic spudger to unhinge the motor platform from the blender.

Unhinge the plastic motor platform from the blender.

You may need a plastic spudger to unhinge the motor platform from the blender.

Step 5

Using a spudger, carefully insert the tip into the coil of wire around motor.
This is used to hold the rotating piece of the motor still.

Using a spudger, carefully insert the tip into the coil of wire around motor.

This is used to hold the rotating piece of the motor still.

Step 6

Remove the white rotor piece by rotating it counter-clockwise.
While rotating, make sure the rotating piece of the motor remains still.

Remove the white rotor piece by rotating it counter-clockwise.

While rotating, make sure the rotating piece of the motor remains still.

Step 7

              Motor

Move the motor platform to the side.
Lift up the motor and remove it from the blender.

Move the motor platform to the side.

Lift up the motor and remove it from the blender.

Step 8

Some soldering experience required!
Desolder the red wire from the green plastic piece.

Some soldering experience required!

Desolder the red wire from the green plastic piece.

Step 9

Cut the thin black wire from the wire cap.

Cut the thin black wire from the wire cap.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Andrew Huff

Member since: 09/04/2015

547 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       USF Tampa, Team 2-5, Sullivan Fall 2015                        

                                                  Member of USF Tampa, Team 2-5, Sullivan Fall 2015 



                    USFT-SULLIVAN-F15S2G5                     


                                            4 Members                     


                                            5 Guides authored

Geo Jack Jack - May 3, 2017

This article appears to be unfinished. You cut 2 wires at the end… then what? Reconnecting them doesn’t make any sense.

hugoalex521 - Apr 24, 2020

Que tipo de motor tengo que comprar?

Introduction#

What you need#

Team#

Introduction

What you need

Team