Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

2

  • Nursery Unit Battery
  • 2 steps
  • LED Nursery Unit
  • 4 steps

Flags

1

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

  • BackGraco Secure Coverage

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

The LED replacement includes the LED and battery replacement.

What you need

Step 1

              Nursery Unit Battery
  • Remove the 9mm screw from the battery cover of the nursery unit using a Phillips #1 tip screwdriver.

Remove the 9mm screw from the battery cover of the nursery unit using a Phillips #1 tip screwdriver.

1024

Step 2

  • Using the plastic opening tool, pry and remove the battery cover carefully.
  • Remove the batteries using plastic opening tool.
  • Replace the batteries.

Using the plastic opening tool, pry and remove the battery cover carefully.

Remove the batteries using plastic opening tool.

Replace the batteries.

Step 3

              LED Nursery Unit
  • Remove the two 9mm Phillips #1 screws from the rare case of the device.
  • Place the screws in a secure place.

Remove the two 9mm Phillips #1 screws from the rare case of the device.

Place the screws in a secure place.

Step 4

  • Hold the bottom of the device with one hand and pull down to separate the front and rare cases.
  • While holding the device with one hand, use plastic opening tool to pry the edges of the front case away from the back case.
  • Apply constant force carefully to avoid breaking any other plastic parts from the device.

Hold the bottom of the device with one hand and pull down to separate the front and rare cases.

While holding the device with one hand, use plastic opening tool to pry the edges of the front case away from the back case.

Apply constant force carefully to avoid breaking any other plastic parts from the device.

Step 5

  • Remove all three 7mm Phillips #1 screws from the mother board.
  • Place the screws in secure place.

Remove all three 7mm Phillips #1 screws from the mother board.

Place the screws in secure place.

Step 6

  • Flip over the motherboard to look at the LED pins that are connected to it.
  • Solder off the LED pin from the motherboard.
  • There are many pins are connect to the motherboard, so make sure that you solder off the LED pin.
  • Replace the LED.

Flip over the motherboard to look at the LED pins that are connected to it.

Solder off the LED pin from the motherboard.

There are many pins are connect to the motherboard, so make sure that you solder off the LED pin.

Replace the LED.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Bryson Wolff

Member since: 08/31/2015

237 Reputation

                                      2 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team 6-5, Remmell Fall 2015                        

                                                  Member of USF Tampa, Team 6-5, Remmell Fall 2015 



                    USFT-REMMELL-F15S6G5                     


                                            4 Members                     


                                            8 Guides authored