Difficulty

Moderate

Steps

6

Time Required

                          45 minutes

Sections

1

  • Battery
  • 6 steps

Flags

2

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackGame Console

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Shut down your GPD Win.

Shut down your GPD Win.

1024

Step 2

  • Remove SD card and duct cover.

Remove SD card and duct cover.

Step 3

  • Remove the six PH #00 screws on the back of the GPD.

Remove the six PH #00 screws on the back of the GPD.

Step 4

  • Carefully insert the pry tool between the keyboard and case.
  • Move the tool around the edge until every clip is released.
  • Carefully lift the back half of the case.
  • You’ll see a small ribbon connector on the right. Use your pry tool to remove it by lifting up.
  • On the right, you’ll see another white connector going to the battery. Use the pry tool and pull back on the connector to release it.

Carefully insert the pry tool between the keyboard and case.

Move the tool around the edge until every clip is released.

Carefully lift the back half of the case.

You’ll see a small ribbon connector on the right. Use your pry tool to remove it by lifting up.

On the right, you’ll see another white connector going to the battery. Use the pry tool and pull back on the connector to release it.

Step 5

  • Separate the two halves of the device.
  • Use the pry tool and slowly and carefully separate the adhesive from the back of the case.
  • Remove old battery.

Separate the two halves of the device.

Use the pry tool and slowly and carefully separate the adhesive from the back of the case.

Remove old battery.

Step 6

  • Use two to three strips of the double sided tape and apply it to the back of the battery.
  • Line up the battery with the lines on the case and the connector on the right.

Use two to three strips of the double sided tape and apply it to the back of the battery.

Line up the battery with the lines on the case and the connector on the right.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Michael d Hinsberger

Member since: 05/19/2020

207 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       University of Advancing Technology, Team S1-G9, Beam Summer 2020                        

                                                  Member of University of Advancing Technology, Team S1-G9, Beam Summer 2020 



                    UAT-BEAM-SU20S1G9                     


                                            1 Member                     


                                            1 Guide authored