Difficulty

Moderate

Steps

3

Time Required

                          5 - 15 minutes

Sections

1

  • Front Assembly
  • 3 steps

Flags

0

  • BackGeneral Wire Drain Cleaner R-SV-D (2014)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove the cable end cover
  • Turn off the drain cleaner and disconnect it from power before beginning any maintenance.
  • Slide the rubber cable cover off of the end of the cable.

Turn off the drain cleaner and disconnect it from power before beginning any maintenance.

Slide the rubber cable cover off of the end of the cable.

1024

Step 2

              Loosen the front assembly screws
  • Use a flathead screwdriver to loosen the three screws around the edge of the front assembly.

Use a flathead screwdriver to loosen the three screws around the edge of the front assembly.

Step 3

              Remove the front assembly
  • Pull the front assembly off of the drain cleaner and slide it over the cable to remove it.
  • During reassembly, make sure the three screws on the front assembly line up with the slots on both the metal cable container back and the plastic cable container.

Pull the front assembly off of the drain cleaner and slide it over the cable to remove it.

During reassembly, make sure the three screws on the front assembly line up with the slots on both the metal cable container back and the plastic cable container.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Adam O'Camb

Member since: 04/11/2015

173,479 Reputation

                                      418 Guides authored                  



                       Badges:
                       39







                                                        +36 more badges